#The signal state solutions drivers#
#The signal state solutions driver#
#The signal state solutions software#

#The signal state solutions driver#

A miniport driver must use revision 3 of this OID and its data structures if the driver supports 5G.įor more info about 5G data class support, see MB 5G data class support. This revision enables the host to query new reference signal received power (RSRP) and Signal-to-Noise (SNR) values from the miniport driver. Starting in Windows 10, version 1903, OID_WWAN_SIGNAL_STATE has been upgraded to revision 3. In the above states, a query to the signal strength must be returned with the following data by the miniport driver:

#The signal state solutions drivers#

Miniport drivers can return this for specific devices that are aware of device capabilities not supporting the signal strength can fail the request with this error code.ĭevices must support signal strength indications.ĭrivers must report signal strength indications of at least 50% of the RssiInterval setting over a time period of five minutes.ĭevices must avoid reporting the signal strength in the following states:ĭevice not registered or deregistered and is applicable only for GSM devices. Miniport drivers can do the following when processing query requests from the MB Service:įail this request with the appropriate uStatus error code set. Miniport driver cache the request data and start reporting the signal strength after the switch is turned ON.Ĭan fail this request with the appropriate uStatus error code set.

#The signal state solutions software#

The miniport driver should try to apply these settings in the next immediate available situation.Ĭomplete the request successfully, if the hardware and/or software radio switch state is currently OFF. Internally cache the RssiInterval and/or RssiThreshold values even if the device is not currently registered with any operator and that any restriction imposed by device in setting parameters can only be possible post-registration state. Return the current values for Rssi and ErrorRate in the NDIS_WWAN_SIGNAL_STATE structure in addition to reporting the absolute values for RssiInterval and RssiThreshold that has been set in the miniport driver. On a set request from the MB Service, miniport drivers should: However, this OID is made available in case the current signal state needs to be determined by the MB Service.įor response to query requests, miniport drivers should send an NDIS_STATUS_WWAN_SIGNAL_STATE notification.

Generally, signal state should be indicated rather than polled. Miniport drivers should not access the provider network, or the Subscriber Identity Module (SIM card), when processing query or set operations. Remarksįor more information about using this OID, see WWAN Signal Strength Operations. Miniport drivers must process set and query requests asynchronously, initially returning NDIS_STATUS_INDICATION_REQUIRED to the original request, and later sending an NDIS_STATUS_WWAN_SIGNAL_STATE status notification containing an NDIS_WWAN_SIGNAL_STATE structure to provide information about the current signal state indication shown to the end-user regardless of completing set or query requests.Ĭallers requesting to set the current signal state indication to the end user provide an NDIS_WWAN_SET_SIGNAL_INDICATION structure to the miniport driver with the appropriate information. OID_WWAN_SIGNAL_STATE returns or sets the current signal state.